BUMPER

5340FSC

01NCB code

512-1637Item number

NIIN 01-512-1637

Identification

Effective date	Major organizational entity	Acquisition advice code	Source of supply	Unit of issue	Unit of measure quantity	Unit price	Quantity per unit pack	Controlled inventory item code	Shelf-life code	Management control	Net price	USC
01-OCT-2026	DN	J	SMS	EA	0.0000	$722.55	1	U	0	9B-----	$0.00	N
01-OCT-2026	DS	J	SMS	EA	0.0000	$722.55	1	U	0	-------	$0.00	I

OVERALL LENGTH	INCHES NOMINAL 17.085
OVERALL HEIGHT	INCHES MAXIMUM 0.750
OVERALL WIDTH	INCHES MINIMUM 2.281 AND INCHES MAXIMUM 2.778
END ITEM IDENTIFICATION	SEAWOLF CLASS SSN; GAS PROCESSING
SPECIAL FEATURES	PART TO BE ANNEALED PRIOR TO FINAL MACHINING; HAS LIP AT EACH SHORT END: 0.23-0.25 IN. THICK X 0.667 INCH LONG; HAS CENTER LENGTHWISE GROOVE: 0.250 IN. WIDE X 0.22 IN. DEEP WITH ARCS AT EACH END WITH RADII OF 0.125 AND BOTTOM ARC CENTERED 0.50 IN. FROM BOTTOM OF PART; PART TAPERS FROM BEING 2.776-2.778 IN. WIDE ON UNGROOVED SURFACE TO 2.281 IN. WIDE ON OTHER SIDE; HAS 0.50 IN. HOLE DRILLED THRU, CENTERED 12.750 IN. FROM BOTTOM END AND COUNTERSUNK 0.54 IN. X 90 DEG. ON UNGROOVED SURFACE
MATERIAL	PLASTIC
STYLE DESIGNATOR
SUPPLEMENTARY FEATURES	DRAWING CALLS THIS: BEARING, SLIDER, ATWARTSHIP

PICA SICA: P
PKG cat: 03AZ
Unpackaged weight: 0.0000
Unpackaged width: 0.000
Unpackaged length: 0.000
Unpackaged height: 0.000
TOS: B
Intermediate container qty: AAA
Quantity set by MIL-STD-2073-1E B.5: up to 100 unit packs, a maximum net load of 40 pounds, and a maximum of 1.5...
Method of preservation: 10
Physical protection
Clng drying: 1
Any suitable process that is not injurious to the item.
Pres mat: 00
No requirement
Wrap mat: 00
No requirement
Cush dun: 00
No requirement
THK: 0
Not applicable
Unit cont: 10
Any suitable container included in this table may be used (see J.4.9.1).
PKG data source: P

PICA SICA: P
SPC MKG: 00
No special marking
Inter cont: D3
PPP-B-566, PPP-B-676, or ASTM D5118/D5118M, folding, setup or fiberboard box.
Lvl A: E
Packing shall be accomplished to meet the performance test requirements of ASTM D4169, Distribution Cycle 18,...
Lvl b: Q
Packing shall be accomplished in accordance with table C-II for the packing level specified.
Unit pack weight: 0.0000
UP SZ MAXB: 0.00000
UP SZ MAXL: 0.00000
UP SZ MAXH: 0.00000
Unit pack cube: 0.0000
OPI: O
Options can be exercised as to specific method of preservation or DoD approved packaging materials to be used.

Your request goes to A-DEFENSE, a US Defense supplier in Texas, who will reply by email.